Goal: Both dots on the lens holder and the laser beam outlet be on the center of the circle.
Directions:
1. Move the laser head to the center of working area manually. Place a piece tape on the metal ring in front of the third reflecting mirror.
2. Close the door and press "Laser Pulse".
3. Open the door and measure the distance between the center of the dot and the center of the ring. Let the distance be X.
4. Release three nuts behind the third mirror. Rotate the three screw equally so the mirror can move forward or backward in a paralleled direction. Make the gap between the metal pieces be X mm.
5. Release the lens holder ring by rotating clockwise and lower the lens holder to about the middle position. Fasten the holder at the position by rotating the ring counter-clockwise.
6. Place a piece of tape to the beam outlet.
7. Refer to the steps of "Third Reflecting Mirror" and readjust the screws behind the third mirror so the dot is on the center of the circle.
8. Release and remove the whole lens holder. Place a piece of tape on the location shown in the picture below. Apply pressure to make a circular mark on the tape.
9. Close the door and press "Laser Pulse". Open the door and check the dot on the tape. There are three possibilities for the location of the shot:
a. The shot is in the center of the circle.
Indicating the optical path is already vertical and the adjustment is done.
b. The dot is on the right side of the circle.
Indicating the optical path has an angle which comes from the top-right and exit to
the bottom-left. Release the each screws counter-clockwise half round to decrease the
gap distance between the metal pieces. Redo step 5 - 9.
c. The dot is on the left side of the circle.
Indicating the optical path has an angle that comes from the top-left and exit to the bottom-right.
Tighten each screws clockwise half round to increase the gap distance between the metal pieces.
Redo step 5 - 9.
Please run the "Camera Calibration" again after the adjustment is done.
Comments
0 comments
Please sign in to leave a comment.