Preparation Items :
1 | Distilled water
Included in the accessory box:
2 | Funnel
3 | Double head wrench
4 | Torx screwdriver
1. Room temperature should not be too high :
a. Keep the right side of the machine heat vent open and should not shade the bottom air intake.
b. Room temperature above 30°C is not suitable for the use of CO2 laser.
2. Water temperature should not be too high :
The water temperature should be between 5°C-30°C.
a. The starting temperature of the water is low, or the machine has good heat dissipation ability, the continuous cutting time can be longer.
3. Reduce the high-power operation time :
a. If the water temperature is too high due to continuous cutting, you should wait for the machine to dissipate heat and the water temperature to decrease before clicking “Resume” for operation. This will not affect the engraving result. A suitable pause in cutting will help to improve the heat dissipation and can effectively increase the continuous cutting time.
b. Arrange engraving works between the cutting jobs so that the laser tube can
have enough time to dissipate heat.
4. The water pump should be at least 80% full :
More water will make the water temperature rise more slowly. If the water level in the water pump is less than 80% full, water should be added 5-5 Water Cooler Maintenance > Press the water hose to discharge the air bubbles inside the laser tube as much as possible. The water-cooling system of this model is a closed water circuit, if the water pump cap is covered, general use will not cause water evaporation, the water level of the water pump drops, if the water level decreases significantly within a week, please contact your reseller.
5. Water cooling fans work normally :
Put the right half of the machine out of the table for testing > Press the “MAINTAIN” on the machine screen > Click “Pump”. After the water pump is turned on, you can reach underneath the machine and feel whether the two water cooling fans have normal air inlet (the air outlet is located on the right side of the machine and the air volume is too small to judge).
Troubleshooting Records :
1. Photo :
Flow speed reading (should be greater than 1.0 L/min)
(“MACHINE” > “Hardware Settings” > “Test Flow Speed”)