Beambox & beamo Firmware 3.2.4

2020-08-27

Fixed:

1. Fixed frequently fail to detect machine in Beam Studio.

Added:

1. Added show water temperature and water flow in the top right corner of screen during engraving/cutting.
2. Added human readable unit (L/min) for test flow speed.
3. Added detection of door open, water temperature and bottom open before start of engraving/cutting.
4. Added error code #904 and QR code redirecting to Help Center for motor homing error
5. Added Air-assist Switch in Hardware Settings.
6. WARNING: Disabling air-assist system may cause flaming combustion. Must only turn it off for special purpose.

Changed:

1. Changed restriction of laser power threshold for beamo model only.
   
   • If 2%~16% laser power is set for beamo, it will be forced to 17% automatically.
   • No laser power threshold for Beambox/Beambox Pro.