2020-08-19
Fixed:
- Fixed laser cutting not emitting light after engraving in some cases.
- Fixed failing to resume after pause.
Added:
- Added support for Beam Air auto On/Off with USB cable.
- Added 17% power threshold, any power setting lower than 17% will be forced to 17%.
- NOTE: The power rate on the LCD panel still apply under 17%.
- NOTE: After 3.2.4, this threshold will be restricted to Beamo model only.
- Added origin-relocate feature, allow to adjust file origin position on machine.
- Added German into supported languages.
- Added closing pump and restricting ventilator power during working of Diode laser.
- Added non-volatile setting of motor direction for Beamo model.
Comments
0 comments
Article is closed for comments.