Beambox & beamo Firmware 3.2.6

Fixed:

1. Trigger any event disable when awake the screen after screen sleep 10 minutes.
2. Fixed the manchine's fan speed does not follow the hardware setting speed after Retry the work.
3. Fixed the wrong trouble shooting message (#900) pop up when the diode laser's work switch to CO2 laser.
4. Fixed the problem of v3.2.5 beta (inclusive before version) with Beam Studio v1.4.5 beta. If Beam Studio shuts down abnormally when the camera is previewed in the software, the control button fails or cannot start working when the machine is in maintain mode.

Added:

1. Add Spanish language version.
2. Add Dutch language version.
3. Add Fire Hazard information panel when start the machine.
4. Add QR-Code link to Help Center on #900 Cooler Abnormal trouble shooting.
5. Add Reset Mainboard Settings button in Hardware Settings.
6. Add "Obtain IP Address Settings from DHCP" in Internet Settings panel. (Wireless and Wired network.)
7. Add the open/close cover status icon during machine working.

Changed:

1. Remove Laser button in maintain mode.
2. Hide "film_files" folder.