This section contains Beam Studio creation, Import Image, Smart Trace, and mass production operation steps.
Beam Studio is designed for FLUX laser engraving machines, which can effectively interface with other professional design software
(see Appendix II 2-1 Design Software Recommendations) for laser engraving; if there are more complex objects and shapes to be engraved, it is recommended to use the method of Import Image, and after importing the drawings, final layout and param- eter settings are made in Beam Studio.
When previewing the Smart Trace image, make sure the least amount of preview is done to avoid the misalignment of the image caused by stitching. If the tracing image is small, you can click the center of the image to place it in one camera preview screen when previewing.
After confirming the position of the fixture and objects in the first editing of mass production project, FLUX task can be exported to the USB flash drive. In the future, you only need to insert the USB flash drive into the machine, focus on the engraving material on the fixture, and then click "START" page to select the file and directly start the engraving job.
（Zoom in : Left）
（Zoom in : Right）