Ador Firmware v5.1.12

This firmware version only supports Beam Studio 2.2.13 and above.

Added

• Support for the web and mobile versions of Beam Studio.
• Added ink level information.
• Added Acceleration Rate adjustment.
• Added module head picture tip during camera calibration.

Fix

• Fixed error when sending the job while the machine was on the "Control" page.
• Turn off the autofocus function during the work.
• Disabled "Low Laser" and "Laser Pulse" functions when the bottom cover is open.

Change

• Adjusted error messages.
• Updated the layout of the Network page.
• Reduced Z-Home speed.