Troubleshooting: #114 Toolhead bad connection FLUX Support Team March 07, 2017 09:08 Updated Please make sure you plug in the toolhead cable to the very end. If this error still appears during printing, please submit a request to our support staff. Related articles Troubleshooting: #110 Toolhead not detected Troubleshooting: #121 Filament not detected Troubleshooting: #164 Toolhead abnormal temperature detected Troubleshooting: #116 Engraving toolhead tilt detected Troubleshooting: #118 Unable to heat printer toolhead Comments 1 comment Sort by Date Votes Roman Habrat March 22, 2016 15:45 It may be useful to scale up the stabilizer a bit.I printed two identical stabilizers and one plug fitted well but another plug (at the other end of the cable) couldn't fit at all. Despite cutting the edges of stabilizer a bit with a knife and despite filing the plug walls with a sandpaper, I was not able to insert it into the stabilizer. Then I printed the stabilizer again but scaling it up one step (15 mm to 15.1 mm) and the plug could be inserted at last. 0 Please sign in to leave a comment.