Please make sure you plug in the toolhead cable to the very end.
If this error still appears during printing, please submit a request to our support staff.
Troubleshooting: #114 Toolhead bad connection
If this error still appears during printing, please submit a request to our support staff.
Comments
1 comment
It may be useful to scale up the stabilizer a bit.
I printed two identical stabilizers and one plug fitted well but another plug (at the other end of the cable) couldn't fit at all. Despite cutting the edges of stabilizer a bit with a knife and despite filing the plug walls with a sandpaper, I was not able to insert it into the stabilizer.
Then I printed the stabilizer again but scaling it up one step (15 mm to 15.1 mm) and the plug could be inserted at last.
Please sign in to leave a comment.