Beambox II - LightBurn Camera Add-On Installation – FLUX Help Center

Description

This article provides a detailed explanation of how to install and use the Beambox II Lightburn camera Add-on. Please follow the steps below to complete the installation.

Inside the Box

Wide-angle camera module
Camera cable
LED fill light strip x2
1-to-2 splitter cable
Cable clips x3
Hex nut socket wrench
Hex nuts x2
Zip tie

Tool Preparation

Phillips screwdriver

Step 1 – Power Off

Before beginning installation, make sure to turn off both the machine’s power and the main switch.

Step 2 – Install the Lightburn Camera Module Cable

2-1 Connect the camera cable to the camera module as shown in the diagram.

2-2 Remove the protective film from the camera module.

Step 3 – Install the Camera Module onto the Machine

3-1 Open the door cover and locate the two mounting studs on the top of the door cover.

3-2 Position the camera module on these studs, then use the included hex nut socket driver and hex nuts to fasten it securely.

IMG_9124 (1).jpg

Screenshot 2025-03-12 at 11.18.34 AM.png

3-3 Using a Phillips screwdriver, remove the screws from the machine’s service cover and open it. (*Double-check that the main power is switched off.)

3-4 Peel the backing off the cable clips, attach them to the indicated spots inside the machine, and then guide the camera cable through the clips.

3-5 Pass the camera cable through the cable management hole on the machine’s side panel.

3-6 Arrange the camera cable neatly and secure it with zip tie.

Step 4 – Connect the Camera Module to the Mainboard

4-1 Locate the USB camera port near the front of the mainboard.

IMG_9172(1).JPG

4-2 Unplug the USB connector currently in CAM2 and plug it into CAM1.

4-3 Plug the Lightburn Camera’s USB connector into CAM2.

Step 5 – Close the Machine’s Service Cover

After Step 4 is complete, the camera installation is done. Close the service cover as shown, and tighten the screws.

Step 6 – Install the LED Fill Light

6-1 The LED fill light strip is magnetic. Please attach it to the inside of the machine, facing the left area.

6-2 Plug the LED strip into the LED board at the front of the machine, then route its cable so it doesn’t interfere with the work area.

6-3 Attach the second LED strip to the inside of the machine, facing the right area.

6-4 Unplug the cable from the front LED board connector and insert a 1-to-2 splitter cable.

6-5 Connect both the original front LED strip and the right-side LED strip to the splitter (order is irrelevant). Afterward, route and secure the LED wiring outside the machine’s working area.