Description
This guide explains how to install a rotary attachment, enable it in LightBurn, and enter the dimensions of your object.
Step 1 - Install the rotary attachment
Please refer to Steps 1 - Step13 to install the Chuck rotary attachment.
Beambox II & HEXA RF - FLUX Chuck Rotary Start Engraving
The installation should be done, and the object should be gripped as shown in the photo below.
Step 2 - Open Rotary Setup
In LightBurn, click the rotary icon highlighted in red at the top right of the screen to open the Rotary Setup window.
The red box marks the Rotary Setup icon:
Step 3 - Enable the rotary and select A Axis
In the Rotary Setup window, turn on the Enable Rotary option. Under Rotary Axis, select A Axis.
Step 4 - Enter the object dimensions
Enter one of the following measurements for your object, using the unit shown in the corresponding field:
- Object Diameter: the diameter of your object.
- Circumference: the distance around your object.
The values in the screenshot are for illustration only. Enter the actual measurement for your object.
Click OK to save the settings.
Check the settings
Reopen Rotary Setup and confirm that the Enable Rotary option is on, A Axis is selected, and the Object Diameter or Circumference value matches the measurement you entered.
#END
Comments
0 comments
Please sign in to leave a comment.