Description
This guide explains how to install an auto-feeder attachment, enable it in LightBurn, and enter the dimensions of your object.
Step 1 - Install the Auto-feeder attachment
Please refer to the selection page below to install the Chuck rotary attachment.
Beambox II - Auto Feeder - Setup Selection Page
|
Note: Stop when the installation is complete. Place and focus the object as shown in the photo below. For example, if you are setting up as "(A)", stop at Step A20, then return to this article. |
Step 2 - Open Rotary Setup
In LightBurn, click the rotary icon highlighted in red at the top right of the screen to open the Rotary Setup window.
The red box marks the Rotary Setup icon:
Step 3 - Enable the rotary and select A Axis
In the Rotary Setup window, turn on the Enable Rotary option. Under Rotary Axis, select A Axis.
Step 4 - Enter the object length
Enter one of the following measurements for your object, using the unit shown in the corresponding field:
- Object Diameter: the length of your object.
- Circumference: ignore this value.
The values in the screenshot are for illustration only. Enter the actual measurement for your object.
Click OK to save the settings.
Check the settings
Reopen Rotary Setup and confirm that the Enable Rotary option is on, A Axis is selected, and the Object length value matches the measurement you entered.
#END
Comments
0 comments
Article is closed for comments.