Unsuccessful update may cause the machine unable to boot up. An SD card reprogram is required. Steps are as follows -
1. Remove the front casing of the beamo, and take out the SD card.
2. Download the system’s ISO file that needed to be burnt to the SD card from the link below –
3. Download the software for burn process: Windows/macOS are generally burnt in the same way. Please select the corresponding software according to your operating system. The link is as follows –
4. Connect a card reader to your computer, and plug in the SD card to the reader.
There is no need to format the SD card before the burning process.
Activate the burn process software, and select your operating system to begin.
This process will take around 20-30 minutes.
After completing the burn process, place the SD card back into the machine. Connect the power supply, and start the machine. If you see the control options appear on the screen panel, then you’re good to go!
*NOTE: After burn process is complete, do NOT cut off the power supply before first activation. This process might damage the system files previously burnt, or cause the SD card to malfunction.