I. Before Getting Started
II. Start
- 2-1 Unboxing
- 2-2 Assembly and Start-up
- 2-3 Software Installation and Activation
- 2-4 Connection Settings
- 2-5 Camera Calibration
- 2-6 Beam Studio Tutorial
III. Software Operation
IV. Maintenance
- 4-1 beamo - Maintenance Checklist
- 4-2 Panel function and screen cleaning
- 4-3 Lubricating
- 4-4 Honeycomb Table Cleaning
- 4-5 Chassis Cleaning
- 4-6 Mirrors and Lens Cleaning
V. Troubleshooting
- 5-1 Contacting Customer Service
- 5-2 Connection Issue Troubleshooting
- 5-3 Unable to Open Software Properly / Software Quits Unexpectedly
- 5-4 Other Software Error Codes
- 5-5 Material cannot be cut through
- 5-6 Camera Issues Troubleshooting (Camera Preview Timeout, Failed to Connect, Blank Photos)
VI. Error Code
- #900 Cooler Off/Cooling system failure
- #901 Door Opened
- #902 Overheated
- #903 Bottom Cover Opened
- #904 Homing Failed
- #905 Error when connecting to the mainboard.
VII. Warranty and Disclaimers
VIII. Add-on Modules
- beamo - Auto Feeder - Setup Selection Page
- beamo - Add-on Introduction
- beamo - Add-on Compatibility
- beamo - FLUX Chuck Rotary Start Engraving
- beamo - Rotary Add-on
- beamo - Autofocus Add-on Installation
IX. Maintenance/Replacement Videos
- beamo - Replacing the Laser Tube
- beamo - Replacing Door Cover
- beamo - Replacing the Auto-Focus Probe
- beamo - Replacing the Camera Cable
- beamo - Replacing the Water Pump
- beamo - Replacing the Mainboard / Raspberry Pi Board