Ador - Door Cover Replacement

Tools

1. Torx T8 driver

__________

Step  1

Turn off the machine and remove the power cord.

＿＿＿＿＿＿＿＿

Step 2

Use a T8 screwdriver to remove the 8 screws on the back of the chassis to loosen the sheet metal and door cover (The sheet metal and door cover are connected together)

＿＿＿＿＿＿＿＿

Step 3

First push the sheet metal and door cover forward or pull back a little to create hand space, as shown in the video.

＿＿＿＿＿＿＿＿

Step 4

Remove the motor cable as shown in the picture.
(The purpose is to make it easier to remove the camera cable)

＿＿＿＿＿＿＿＿

Step 5

Remove the camera cable by first opening the clip and then pulling out the camera cable.

Clip closed

Clip opened

The camera cable pulled out

＿＿＿＿＿＿＿＿

Step 6

The door cover and the sheet metal can now be completely removed.

＿＿＿＿＿＿＿＿

Step 7

Place the new door cover on the machine, leaving space to allow your hand to reach inside the machine.

＿＿＿＿＿＿＿＿

Step 9

Insert the camera cable back into the board and make sure to close the clip.
Please note that the metal side of the cable needs to be facing the mainboard or yourself.

The metal side of the cable

The metal side has to be facing the board or yourself

Insert the cable

Close the clip

＿＿＿＿＿＿＿＿

Step 9

Plug in the motor cable.

＿＿＿＿＿＿＿＿

Step 10

Push the door cover and the sheet metal toward the fan to the end and screw the 8 screws.

＿＿＿＿＿＿＿＿

Step 11

If the steps above are done, it indicates the replacement has been finished successfully.

However, during the steps, the camera has been changed, so before you proceed to use the machine, please perform a camera calibration.
Please refer to the page: Camera Calibration

＿＿＿＿＿＿＿＿

#END