I. Before Getting Started
- FLUX Ador LSO Training
- 1-1 Welcome
- 1-2 Safety Precautions
- 1-3 Labels
- 1-4 Specs
- 1-5 Laser Engraving Principle
II. Start
- 2-1 Assembly and Start-up
- 2-2 Software Installation and Activation
- 2-3 Setting Up the Connection
- 2-4 Start Engraving
- 2-5 Camera Calibration (Diode Laser)
- 2-6 Accessories Description
III. Software Operation
IV. Maintenance
- Ink Cartridge Usage Guidelines
- Maintenance Checklist
- 4-1 Lubricating
- 4-2 Laser Module Cleaning (10W/20W Diode Laser Module)
- 4-2-1 2W Infrared Laser Module Cleaning
- 4-3 Door cover, Work area and Touch panel cleaning
V. Troubleshooting
- 5-1 Customer Service
- 5-2 Connection Issue Troubleshooting
- 5-3 Unable to Open Software Properly / Software Quits Unexpectedly
- 5-4 Other Software Error Codes
- 5-5 Bad Engraving or Cutting Result (Diode Laser)
- 5-6 Camera Preview Timeout or Failed to Connect
VI. Error Code
- #813 No Calibration Data / No Calibration Photo Uploaded
- #901 Door Open / Start-up Test Failed / Door Detection Problem
- #903 Bottom Open / Bottom Detection Problem
- #904 Homing Failed / Homing Issues / Not able to home
- #916 Z-Axis Homing Failed/Vertical Homing Issue/Auto-Focus Function Fail
- #919 Printing module no response
VII. Warranty & Disclaimer
VIII. Add-on Modules
- Ador Extension Base - Unboxing and Installation
- Ador - Honeycomb Installation
- Ador - Passthrough Engraving Guide
- Ador - Passthrough Printing Guide
- Ador Rotary - Unboxing and Installation
- Ador Rotary - Start Engraving
IX. Maintenance/Replacement Videos
- Ador - Z-axis Module Seat Holder Replacement
- Ador - X-axis Motor Replacement
- Ador - Air Hose for Module Seat Replacement
- Ador - X-axis Board Replacement
- Ador - Y-axis 38-Pin Cable Replacement
- Ador - X-axis 30-pin Flat Cable Replacement