Recommended Frequency
Once an operation, especially for cutting, involves a lot of debris.
To avoid the possible fire hazard due to the left of small pieces of cutting materials on or beneath the honeycomb table, it is recommended to clean the honeycomb table right after use. Debris inflammation is one of the most common causes of fires in laser cutters.
Preparation Items
- Vacuum cleaner or brush
- 75%~99% alcohol
- Paper towel or tissue paper
Maintenance Steps
1. Take the honeycomb table out
⚠︎ The mesh part of the honeycomb table is relatively sharp, so please be careful when holding it.
2. Clean the chassis
- Use a vacuum cleaner or brush to clean the large residue and dust.
- Spray the bottom of the chassis evenly with alcohol.
- Wipe it with a paper towel or tissue paper after a minute to remove the tar.
3. Put the honeycomb table back
Place the honeycomb table at a 45-degree angle into the chassis and lay it flat.
#END
Comments
0 comments
Please sign in to leave a comment.