beamo II Guide

I. Before Getting Started

• 1-1 Welcome
• 1-2 Safety Precautions
• 1-3 Labels
• 1-4 Specs

II. Start

• 2-1 Assembly and Start-up
• 2-2 Software Installation and Activation
• 2-3 Setting Up the Connection
• 2-4 Camera Calibration
• 2-5 Start Engraving
• 2-6 Safety Key Function Guide

III. Software Operation

• 3-1 About Beam Studio

IV. Maintenance

• 4-1 beamo II - Maintenance Checklist
• 4-2 Panel
• 4-3 Lubricating
• 4-4 Mirrors and Lens Cleaning
• 4-5 Chassis Cleaning
• 4-6 Honeycomb Table Cleaning

See all 16 articles

V. Troubleshooting

• 5-1 Contacting Customer Service
• 5-2 Language Settings
• 5-3 Skip or Restart the Start-up Test
• 5-4 Connection Issue Troubleshooting
• 5-5 Unable to Open Software / Software Quits Unexpectedly
• 5-6 Other Software Error Codes

See all 15 articles

VI. Error Code

• #900 Low Coolant Flow/Cooler Off/Cooling system failure
• #901 Door Opened/Door Issue/Door cover can’t be closed
• #902 Overheated / The Water Temp is too high / It’s too hot.
• #903 Bottom Open / Bottom Detection Problem
• #904 Homing Failed/Homing Issues/Not able to home
• #910 Z-axis Homing Fail

See all 13 articles

VII. Warranty & Disclaimer

• 7-1 Warranty
• 7-2 Disclamer

VIII. Add-on Modules

• beamo II - Passthrough Engraving Guide
• beamo II - 2W IR Infrared Laser Add-on - Unboxing and Installation
• beamo II - 2W IR Infrared Laser Add-on - Calibration Guide
• beamo II - Extension Base - Unboxing and Installation
• beamo II - FLUX Chuck Rotary - Start Engraving
• beamo II - Auto Feeder Guide

IX. Maintenance/Replacement Videos

• Chuck Mainboard Replacement Guide
• beamo II - Laser Tube Replacement Guide
• beamo II - X-axis 34-pin Flat Cable Replacement
• beamo II - Z-axis Board Replacement
• beamo II - X-axis Board Replacement
• beamo II - Auto-focus Probe Replacement

See all 18 articles