Temporary OPA Tool Guide

Description

This article will guide you through how to make an OPA tool.
Please ensure that the dimensions are drawn or trimmed as precisely as possible.

Overview

You only need to find a 50mm x 25mm transparent piece (Which Can be trimmed to size) and draw three lines as per the dimensions shown in the red lines in the photo below.
(You can find your own way as long as the dimensions of the lines are correct.)

Step 1

• Find a piece of transparent tape or any transparent piece that can be drawn on and cut.
• If you are using tape, fold the tape to enclose the sticky part or combine two pieces.
• After closing the sticky part, the length for this piece is at least 50mm, and the width is at least 25mm.  (A longer length is okay, as you can trim it.)

Step 2

• Find the vertical 10mm spot and mark it.
  

• Draw a vertical line based on the mark throughout the transparent piece.
  

Step 3

• Find the vertical 16mm spot and mark it.
  

• Draw a vertical line based on the mark throughout the transparent piece.
  

Step 4

• Find the horizontal 11mm spot and mark it.
  

• Draw a vertical line based on the mark throughout the transparent piece.
  

Step 5

Trim the piece to be 50mm x 25mm.

Step 6

Make a mark on the 10mm side.

Step 7

Please refer to the Optical Path Alignment Guide for instructions on using the tool.
4-11 Advanced Optical Path Adjustment

#END