I. Before Getting Started
II. Start
- 2-1 Unboxing
- 2-2 Assembly and Setup
- 2-3 Software Installation and Activation
- 2-4 Setting Up the Connection
- 2-5 Camera Calibration
- 2-6 Beam Studio Tutorial
III. Software Operation
IV. Maintenance
- 4-1 HEXA - Maintenance Checklist
- 4-2 Panel
- 4-3 Lubricating
- 4-4 Honeycomb Table Cleaning
- 4-5 Chassis Cleaning
- 4-6 Mirrors and Lens Cleaning
V. Troubleshooting
- 5-1 Contacting Customer Service
- 5-2 Connection Issue Troubleshooting
- 5-3 Unable to Open Software / Software Quits Unexpectedly
- 5-4 Other Software Error Codes
- 5-5 Material cannot be cut through
- 5-6 Camera Issues Troubleshooting (Camera Preview Timeout, Failed to Connect, Blank Photos)
VI. Error Code
- #900 Cooler Off/Cooling system failure
- #901 Door Opened/Door Issue/Door cover can't be closed
- #902 Overheated/The Water Temp. is too high/It's too hot.
- #904 Homing Failed/Homing Issues/Not able to home
- #910 Z-axis Issue/Auto-focus Issue/Honeycomb Platform Issue/Workbed Problem/Bad Focus Distance
- #911 Drawer Opened
VII. Warranty and Disclaimers
VIII. Add-on Modules
- HEXA - Add-on Introduction
- HEXA - FLUX Chuck Rotary Start Engraving
- HEXA - Rotary Module 2.0 Installation Guide
- HEXA - Rotary Module 1.0 Installation Guide
- HEXA - 1.5 inch Focus Lens Add-on Installation Guide
- LightBurn Bridge Cable - HEXA
IX. Maintenance/Replacement Videos
- HEXA - Round Switch (Silver Color) Replacement
- HEXA - Major Fan Replacement
- HEXA - Rotary 2.0 Mainboard Replacement
- HEXA - Camera Cable Replacement
- HEXA - 12V PSU Replacement
- HEXA - Fire Sensor Cap Installation Guide